BRP Evinrude Spezifikationen PDF herunterladen (Seite 58)

OUTBOARD RIGGING

EVINRUDE E-TEC 90° V MODELS 200–300 HP

For an I-Command oil level display, an accessory

CANbus oil level sender must be installed in the

oil tank. Connect the sender to the I-Command

network. Refer to the I-Command Digital Net-

work Guide, P/N 355008.

Use Evinrude Diagnostics software to adjust net-

work settings in the EMM. From the Settings

screen, select Engine Options.

ICON Network Connections

If the outboard is equipped for an Evinrude ICON

control system, connect the outboard to the net-

work as follows.

Refer to Evinrude ICON / I-Command Harness

Connections on p. 14.

Connect the buss cable from the rear network hub

to the outboard’s network harness.

IMPORTANT: Do not force connectors or lock-

ing rings. Properly aligned connectors assemble

easily.

DO NOT use Electrical Grease on ICON buss

cable connectors.

To assemble the connectors:

• Use the large tabs and small tabs to carefully

align buss cable connectors.

• Carefully align pins and sockets of connectors.

Do NOT force connectors together.

• Tighten locking rings of buss connectors finger

tight. Do NOT use locking rings to force connec-

tors together.

Do not rotate connectors until they align. This

could result in a mismatched connection. It is pos-

sible for each pin to enter a socket even if the tabs

are misaligned. Look at the tabs to ensure con-

nector alignment prior to making the connection.

Engine Monitor information is distributed to an

ICON or I-Command network through the ICON

gateway module. Refer to the I-Command Digital

Network Guide, P/N 355008.

The ICON Harness and Relay Kit, P/N 765296,

must be used to provide power to boat accesso-

ries that require switched B+. This kit is used in

place of connecting accessories to the “A” termi-

nal of the key switch. Accessories connected to

the accessory power relay should not exceed 7

amps.

Do not connect boat accessories to

the key switch of an ICON system. Connecting

accessories to the key switch can cause low

Engine Options Screen 008013

1. ICON network connector 008001

1. Large tabs

2. Small tabs

007883

NOTICE

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 101 102

Kommentare zu diesen Handbüchern

Keine Kommentare

Sony MZ-EP11 User Manual (2 pages)

Brand: Sony | Category: No info | Size: 0.26 MB |

Getting Started A

Playing an MD B

Procedimientos

Reproducción de un

More products and manuals for Unknown Sony

Models	Document Type
DSC-HX350	User Manual Sony DSC-HX350 User manual, 36 pages
BC-VW1	User Manual Sony BC-VW1 User manual, 2 pages
SRS-A33	User Manual Sony SRS-A33 User manual, 2 pages
DAV-DZ880W	User Manual Sony DAV-DZ880W Brugermanual, 2 pages
HDR-AS15	User Manual Sony HDR-AS15 Kasutusjuhend, 2 pages
HAP-Z1ES	User Manual Sony HAP-Z1ES Guide de démarrage rapide, 2 pages
DSC-RX100M2	User Manual Digital Still Camera [cs] [da] [de] [en] [es] [fi] [fr] [hu] [id] , 40 pages
NWZ-E463	User Manual Sony NWZ-E464 Quick start guide, 2 pages
STR-DH750	User Manual Sony STR-DH750 Schnellstartanleitung, 2 pages
XR-C2300R	User Manual Sony XR-1300R User manual, 4 pages
NEX-3A	User Manual Sony NEX-3A User manual, 7 pages
DSC-QX10	User Manual Sony DSC-QX10 Vodnik za hiter začetek, 4 pages
NWZ-A867	User Manual Quick Start Guide, 2 pages
VPL-CX85	User Manual Data Projector, 30 pages
DSC-T90	User Manual Sony DSC-T90 Istruzioni per l'uso, 174 pages
VGN-FS315M	User Manual Sony VGN-FS315M Bruksanvisningar, 198 pages
HT-DDW2500	User Manual Sony HT-DDW2500 User manual, 2 pages
DPF-C700	User Manual Sony DPF-C700 Bedienungsanleitung, 2 pages
NWZ-E463	User Manual Sony NWZ-E463 Instrucciones de operación, 8 pages
DSC-S800	User Manual Sony DSC-S800 User manual, 105 pages